Note: Check the Category Tree on the left for possible Sub Categories that may help narrow your search.

ESC 30 A Brushless 2-3 Li-Poly - Heli - BP
	Quantity in Basket: none Code: 30A-H-BP Price:$19.95 In Stock
	Quantity:
30A Helicopter Brushless ESC Weight: 28.3 g / 1 oz Size: 55 x 25 x 10 mm ESC and 40 x 25 x 5 mm BEC Constant Current: 30 A Max Current: 40 A for 60 sec BEC: 3 A TIMING: 0 PWM: 8K Input: 2-3 cell Li-Poly Low-Voltage Cutoff: Auto - 3.0V / cell Li-Poly Features: Low resistance Soft start ramp up /Low torque start User programmable Governor Mode User programmable low-voltage cutoff type (Lipo or NiCd/NiMH) Throttle range self-adjusting 8khz PWM For 4-10 NiCd/NiMH cells, 2-3 Li-Poly Cells 40A Max on 3 Li-Poly Auto motor cutoff with reset Auto shut down when signal is lost Max RPM: 20,000 RPM with 14 pole motor Max RPM: 35,000 RPM with 8 pole motor BP 30A Helicopter Brushless ESC Programming Guide PDF Special Instructions: Never exceed the recommended battery voltage listed on the package. Do not use a separate battery supply with this controller. Never disconnect the battery supply when the motor is running. We strongly suggest that you use an overload fuse in the battery circuit. For example, a motor will run at 4 amps therefore a 5 amp speed controller is adequate. If the motor is stalled or stopped, with the power on, then it will draw 15 to 20 amps and burn out the speed controller. An overload fuse can prevent this type of damage. Also, the BEC provides a regulated power supply to the receiver. Usually about .5 amps. A stalled servo can draw 2 or 3 amps and damage the BEC which in turn can cause damage to the receiver. NOTE: SlickZERO Hobby Products assumes no responsibility for the improper use and installation of this product.